Taps with knives "Русский Инструмент"
Prefabricated taps are used to save tool materials when cutting threads of large diameters to compensate for wear.
It is also an advantage that the cutting parts of the tap can be installed on the same housing for threading different steps, the possibility of installing plates made of various tool materials significantly expands the capabilities of the tasks performed by one tap.
|
|
Broach taps "Русский Инструмент"
The broach tap is used for threading a large profile, for example trapezoidal, in through holes. The teeth of the broach tap, having a gradual increase in the size of the average diameter, sequentially, turn by turn, clean the sides of the thread, and the thread turns out clean and accurate in profile. Processing is performed in one pass on any universal lathe.
It is characterized by increased strength and rigidity, since, unlike conventional taps, they do not work for compression, but for stretching. Allows you to reduce the thickness of the cut layer by increasing the length of the cutting part.
|
|
Pre-assembled wrench with safety sleeve "Русский Инструмент"
The advantage of the prefabricated tap design is the saving of tool materials. At the same time, there are no losses in the accuracy and quality of the thread being cut, and a quick replacement of the replaceable cutting part of the tap is more convenient and economical than replacing a one-piece wrench tap. This provides great performance.
|
Tap with wear-resistant coating "Русский Инструмент"
Under normal processing conditions, standard taps made of uncoated high-speed steel are sufficient, but for taps of large diameters due to the high cost, it is important to keep the tap working as long as possible. The use of a wear-resistant coating allows you to solve these problems, namely, prevents the oxidation of the tool, chip sticking, overheating of the cutting edges, rust formation.
|